xCubes
  1. Home
  2. 10×10

10×10 cube solver

Paint every sticker to match your cube or fill it from photos, then press Solve.

Step 1. Orient the cube

  • 1Any face toward you (that is face 1)
  • 5Remember which face is on top (face 5)
  • ↻Then turn the cube as the model shows

A 10×10 has no center cell, so face colors do not matter — only turning the cube correctly between faces does. Hold it the same way when solving.

Step 2. Enter colors for all 6 faces

Pick a color from the palette, then click cells. Right-click (or long-press on a phone) — erase a cell. Use the «Fill solved» button to start from the solved state.

← → switch faces

About the 10×10 cube

The 10×10 is a collector's cube more than a practical one. Even-layered with no fixed centres, it combines the parity problems of the 4×4 with a centre phase that runs into the hundreds of moves. Very few people solve one regularly by hand.

How it is solved by hand

Reduction. The centre phase alone typically takes more moves than an entire 5×5 solve, and edge pairing runs in four passes.

What the cube is made of

  • 8corner pieces
  • 96edge pieces · 8 per edge
  • 384centre pieces · 8×8 per face
  • 600stickers in total

Positions you can reach by scrambling the 10×10: 8.29 × 10349 — a number with 350 digits.

Cubes of this size are usually pillowed — the faces bulge outward — because a true cube shape would make the corner pieces impossibly thin.

If you own a 10×10, spend a few minutes turning it before you scramble seriously. New large cubes often have uneven tension, and a single tight layer will make long move sequences tiring. When you follow a solution, keep the cube on a table or in your lap between phases instead of holding it in the air — it saves your wrists and keeps the grip consistent.

Entering the 10×10 into the solver

With no fixed centres, start the 10×10 by choosing face 1 and remembering the top. Every face has 100 stickers, 600 in total, so photo input is strongly recommended. The centre block is an 8×8 grid on every face; after scanning, compare a few rows with the real cube before you press Solve.

Common mistakes

  • Rotating the cube a different way than the model shows. There is no centre to catch the mistake.
  • Scanning in mixed light. A lamp on one side and daylight on the other make red and orange hard to tell apart.
  • Expecting a short solution. The centre phase alone runs to hundreds of moves.

Questions about the 10×10

Why do very large cubes look puffy?
The faces are pillowed so the corner pieces can be thick enough to stay attached. A flat 10×10 would have corners too thin to hold.
Does a 10×10 have parity?
Yes. It is even-layered, so both edge parity and swapped pieces can appear at the end, and the solver handles them.
How should I follow a solution this long?
Phase by phase. Finish one phase, check that the cube looks the way that phase describes, then move on.